Wednesday, 30 August 2017

How to install a flagpole in the ground

How to install a flagpole in the ground

How much does it cost to install a flag pole? How do you install a flag pole rope? How to attach a flag to a flag pole? Find a good location for your flagpole , which should be located at least feet away from any overhead wires.


Dig a hole using your posthole digger. Pour about inches of small gravel in the bottom of the hole for drainage under the flagpole. Insert the stop bolt that comes with the flagpole into the predrilled PVC sleeve. When you move, just pull the flagpole from the sleeve. You could put in a set pin to lock it.


He will love having you help with his new flagpole. Got It Made 107views. Titan Flagpole Install Instructions - Duration: 6:03. Ric Eborall 4views. Place the bottom swedged section of the pole into the ground sleeve.


Pour concrete mix into hole and around sleeve to within 1. Brace pole and use a level before concrete sets in order to achieve a straight pole. Read instructions completely. A larger hole may be required for soft or sandy soil. Free 2-day Shipping On Millions of Items.


Be careful to keep the inside of tube clean and free of concrete. Re-plumb the ground tube before the concrete sets by temporarily inserting the bottom section of the pole and plumbing it with a level. Feed the halyard through the pulley. From part to part we will remove an existing flagpole and check up on the flagpole after months of flying the same flag!


How to install a flagpole in the ground

STEP - Select a good location for placing your flagpole , check and make sure there are no power lines above or below ground. At the base of the hole I poured two inches of pea gravel. I gently twisted the PVC tub into the pea gravel one inch deep. The end of the tube was sticking approximately one inch above the ground. We recommend this flagpole to almost any home residence or small business.


It is a great flagpole. Dig the hole to the same height as the ground sleeve minus The hole diameter should be times the diameter of the flagpole. Fill the bottom of the hole with loose gravel. Use a level that fits inside of the ground sleeve. Set the ground sleeve in the center of the open hole.


How to install a flagpole in the ground

Position the PVC sleeve at the center of the hole, its top flush with the ground level, and secure it in such a way that it will remain perfectly vertical and not move when pouring concrete. Fill in the hole with concrete around the PVC sleeve, making sure that it stays vertical, up to the top of the ground level. Old rope on left, new rope on right. Line them up end to end. Ground Set Ground Set installations are the strongest and most common form of flagpole installation.


They require burial of the flagpole shaft in a concrete foundation to a depth equal to of the mounting height. All standard Flagpoles listed on this web site are designed for Ground Set foundations. Stand it up and keep it dry until you are ready to install it.


You should dig a hole four times larger than the diameter of the pole. It should also be deep enough so the flagpole ground sleeve is flush with the surface. Do not use sand or dirt as fill around the sleeve.

No comments:

Post a Comment

Note: only a member of this blog may post a comment.