Monday, 23 April 2018

Cutting in painting

Superb Cut-In Ability. How to cut a straight line while painting? How do you cut in when painting walls? What kind of paint brush to use for cutting in?


Cutting in painting

Then make a second pass, cutting in all the way to the trim. The only specialty supplies you need for cutting in are a 2-inch brush and a cut bucket. Pros recommend an angled brush, often called a sash brush. A cut bucket is simply a paint bucket that has no inner lip to collect excess paint. There are small commercial buckets you can buy, usually equipped with a small handle for convenience, but any plastic bucket will work, provided it has straight sides.


Cutting in does take practice, but taking the time to cut in neatly will make a huge difference in the appearance of your newly painted room. So you’re removing the paint from one side of the brush. Now with the paint filled side of the brush facing the wall, paint a short , downward stroke about a quarter to a half inch away from the edge. Cutting-in, sometimes called trimming in, is a process of painting with a brush next to trim , mouldings or adjacent surfaces usually in preparation of using a roller to fill in the large areas of wall surface.


The neatness and quality of the cutting-in can make or break the looks of a painting project. Paint edgers are typically used for wall painting, such as above baseboards , below crown molding , around window and door trim , and at the juncture between two walls , such as for accent walls. Free 2-day Shipping On Millions of Items. Holding the brush with a pencil grip for control, make a brushstroke on the wall about two inches away from the edge you’re cutting in, to remove the excess paint.


This should be about inches long. You can see where the paint is smoth because it was done with a brush. I cut in with a brush ,then right away I have a 2′ roller with the sae size nap that I will be painting the wall with.


Cutting in painting

I roll over the cut in as close as I can without hitting the ceiling. Conditioner or paint extender gives painting a smoother flow, making it easier to achieve a crisp, straight line. Put some painter’s tape or masking tape on a wall and spend some time practicing the cutting -in technique next to the line.


To begin painting , pour about an inch or two of paint in the cut bucket. Cutting in” is the technique of painting a stright line and boarder of paint on the wall that you are about to paint, and only on the wall. Apprently it is called “Trimming In” in North America, but the techniques are exaclty the same. When you’re painting with a roller, you can’t get right up to the edges were the walls meet the ceiling or the walls intersect with each other. Filling in this area is called “Cutting in.


Cutting in painting

Use this method for painting next to the molding, trim, and baseboards as well. These are areas rollers or sprayers cannot neatly reach. Cutting in is the art of drawing a straight line, separating two colors using only the paint brush - no masking tape or other aid. You often see it at the edge where a wall color is cut into a different ceiling color.


When the paint starts to dry along the upper portion of the paintbrush, stop and wash the bristles in clean water. Then spin the bristles dry and continue cutting in painting. If painting the baseboards after painting the walls, then allow the cut- in paint to overlap slightly onto the top edge of the baseboard.


Traditional way is to paint ceilings first. And then do all the trim last. And if you are going to double coat the walls there is also a little twist.

No comments:

Post a Comment

Note: only a member of this blog may post a comment.