How to light a water heater

Set the knob on ‘pilot’ position. Hold the knob down. Light the pilot and keep holding for – seconds. This allows the gas to. There should be instructions somewhere near the pilot light.

There is a little capsule thingie that gets heated up by the pilot light, and when the pilot light goes out, it cuts off the gas to the pilot light. So you turn the knob to a. How do you light an electric water heater? How to relight your hot water heater?

Then, start the flow of gas by setting the gas valve to the “Pilot” position and pushing down on it. To light this type or water heater , I suggest grabbing a long barbecue lighter. The pilot will be a little tricky to reach otherwise.

First, take off the plate that is below the box with dials on. Some water heaters have a separate button for pilot mode, usually a red one, which you’ll press and hold. While still holding the gas down, light that pilot.

If you have shut off your water heater for draining or repairs or to conserve fuel while away on a trip, you must relight the pilot manually. Tank-type gas water heaters use a pilot light to ignite the gas burner when the water in the tank needs to be heated. Usually, the first warning.

If you have questions about your home improvement or maintenance projects, stop by the forum on our. If your water heater has an ignitor , press down simultaneously on the pilot valve and the red ignitor button. Continue to apply pressure until you see the pilot light ignite, and then for another.

With standard pilot light water heaters: Turn the gas control knob to the PILOT setting , then depress the button and hold it there. With the other han use a long-handled lighter to apply flame to the end of the pilot light gas tube. The spark electrode sends intermittent high-voltage sparks to light the pilot.

If the spark electrode won’t produce sparks, it is lik. Free Shipping On All Orders! When your pilot light goes out on your water heater it can be a very annoying experience. In most modern homes, the light is continually fed by a gas line that keeps a slight flame burning so that it can be ready to scale up when it is needed to heat the water tank above it. Most water heaters have a small access panel covering the pilot light.

Depending on your model, it might simply snap on and off, or you might need to use a screwdriver to remove the panel. The standing pilot on a water heater can go out for a number of reasons. To relight it, use a procedure that starts with turning the valve control to Pilot and lighting the flame with a lighter or spark ignitor.

Caution: If you smell gas do not proceed with lighting the pilot on your water heater. Instead contact your local gas. Call a water heater technician immediately. Water heaters are capable of exploding should certain parts in their design fail.

Appliances with complex electronics generally must be replace but simpler ones such as gas water heaters might be salvageable. A certified plumber is always the best resource to repair (or replace) major flood damage, but the relighting process is fairly simple. Watch how you can relight your pilot light and get hot water back running.

So therefore, we will have to find our own way in relighting the pilot using our flame. Tip: you can use a lighter which has a long stem for maximum safety. The manufacturers standard re lighting steps must always be followed and then when it comes to igniting a pilot flame the bbq lighter performs the duty of what a piezo igniter could normally do. If the igniter fails, the burner will not light.

To determine if the igniter is defective, first make sure the igniter is getting voltage.