Installing baseboard molding

How to install new baseboard? How do you install a baseboard? For a more traditional look, add cap molding to the top of the baseboards. Set cap molding atop baseboard trim, placing it flush against the wall. Use the same technique to install the cap molding as you would with the shoe molding.

First hold the base molding against the wall after you cut it to length, and look for gaps. If you see some, cut a few braces from 4- to 6-in. Nail the baseboards in place with finishing nails. Tack the shoe molding down into the floor with pin nails. Apply caulking to sections of.

As you install baseboard , or any trim for that matter, expect to do some re-cutting. It’s all part of the game. Be careful to not leave yourself too short, though.

Actual costs will depend on job size, conditions, and options. Avoid The Stress Of Doing It Yourself. Use a stud finder to locate the wall studs in the installation area.

Step 2: Cut the First Molding Piece. Measure between the two opposing walls for the first piece of baseboard. Plastic baseboard molding may come in a few more colors or styles than the traditional molding materials. Butt the free end of the molding against the inside corner or door frame on one end of the wall.

Store the material at room temperature for three to four hours prior to installation to allow it to acclimatize and become flexible. Work from right to left and begin installation against the door molding at the entrance to the room. When installing baseboard and you come to a door casing, you’ll always cut the baseboard at a 90-degree straight cut. Set your miter saw (or miter box) to 90-degrees.

It will look something like this: with one end butted up against the door casing. In most of the cases the wall baseboard moldings are attached directly to walls and not to the floor, as they are very flexible and designed to conceal the curved walls. Make a miter cut on one boar then clamp the piece to a worktable. Using a utility knife, file, or sander, trim the pointed edges left by the miter cut to help prevent slips. Turn the blade of your coping saw degrees to the frame of the saw and back-cut along the lead edge of the.

Measure, cut (miter and coped end per section) base molding and finish nail molding. Patch and smooth nail holes and if painting caulk edge gaps. Nail baseboard in place with 2-inch finish.

The most common baseboard corner is an inside degree corner, and the easiest way to install baseboards to fit this corner is to cut two pieces of the baseboard at the edges and at an angle so. When planning your baseboards for inside corners, they’ll be positioned with. When cutting outside corners, cut your baseboard moldings with 45-degree. Position the board against the wall and fasten it to the wall plate and studs (as applicable) with a nail gun or hand-driven finish nails.

When I showed you guys my inspiration ideas for redoing the hall bathroom, I showed you this new molding idea. It is a composite wide molding that is sculpted to fit right over your narrow molding without having to remove it. Unfinished solid wood moulding is the most common decorative moulding used in homes. Without the baseboards , the room looks incomplete, unprofessional, and awkward at best.

Well, the good news is we’ve designed this guide to teach you every aspect you must consider while selecting the right size of nails for your baseboard. Pre-drill your nail holes if you are concerned about the baseboard splitting. Baseboards are an important part of a room’s finish.

You want to use a drill bit which is slightly smaller than your nail size.