How to scrape a popcorn ceiling

What is the best way to repair a popcorn ceiling? How to remove a popcorn ceiling easily? How do you replace a popcorn ceiling? Removing popcorn ceiling is an incredibly messy endeavor that requires quite a bit of. Step - Cover Walls and Floor.

After you have emptied the room, cover the vertical walls and floor of the room with. Only give it a light misting—too much water could damage the drywall or loosen the joint tape. Popcorn ceilings conceal imperfections that will become visible once the surface is uncovered. Sand the ceiling once the repair work is dried but keep the sanding to a minimum so that you don’t damage any areas. If you come across a visible nail or screw below the surface, cover it with joint compound.

Allow it to fully dry, then sand the area. Fill the sprayer with warm water and pump it to raise the pressure. Lightly spray a four-foot square test area of the ceiling and let it sit. If your ceiling only has textured product but no paint, it should readily absorb the water and be ready for scraping in about minutes.

To make the task of scraping easier, spray the ceiling with water before carefully scraping away the popcorn texture, says Krzyston. Use a water spray bottle to wet a four-by-four-foot area of the ceiling , let sit for minutes to let water absorb, then scrape. Let it sit for about minutes. Don’t over saturate the popcorn coating, as it could damage the underlying drywall surface. The grid holds tiles in place.

Drop ceilings are often found in basements, but you can use them in other spaces if you like the look they create. Free 2-day Shipping On Millions of Items. Fill a garden sprayer with lukewarm water and spray the entire ceiling.

Give the water about minutes to soak in and soften the texture, and then test a small spot with a putty knife. Work in an area about five feet square. It’s better to make several passes than to allow the popcorn ceiling to absorb too much water, which could damage the paper surface and the wallboards underneath.

After minutes, spray the entire ceiling again. Wait a few minutes and then test an area to see if the popcorn will come off. When it’s ready, that stuff will just slide right off as you push the spackle knife along the ceiling.

Follow these steps for removing a painted popcorn ceiling : To help breakdown the paint, spray a mixture of one part vinegar to ten parts water on the surface of the ceiling. This method is messy and slow, but it works. If you wipe the ceiling and the popcorn wipes off (which means it’s absorbing the water), then it isn’t painted.

It should come off very easily. If not, soak it some more, but be careful not to soak the ceiling too much. Although there is a way to fix the ceiling without removing the texture, the easiest and least expensive option is to scrape off the popcorn and retexture. With unpainted texture, the most common approach is to mist it with a spray bottle and scrape off the softened texture. Use a popcorn scraper that allows most of the popcorn to fall directly into a trash bag.

Make sure you use eye, nose and mouth protection, especially during the sanding. It makes a lot of dust that is very bad. Try to keep your scrapper at the closest angle to flat as possible, roughly degrees.

Fact: A wet scrape is easier than a dry scrape. Spray the Ceiling With Water Before Carefully Scraping Away the Popcorn Texture. Use a garden sprayer to wet a four-by-four-foot area of the ceiling. Simply because removing popcorn ceilings can be fussy and unsafe, especially with the presence of asbestos.

Doing this type of job can be very frustrating because it can also get pretty messy. So, to remove popcorn ceiling safely and with a lot less fuss, there are do’s and don’ts as best practices. Keep in mind that scraping the popcorn texture off your ceiling may be simple enough, but repairing the drywall beneath is a significant undertaking.

Consider enlisting the help of a professional to thoroughly smooth out and repair the ceiling before painting or applying a new texture. To make scraping off the popcorn texture easier, experts suggest lightly misting the ceiling with a garden pump sprayer. Starting from one end of the room, scrape the popcorn texture off the ceiling with the resurfacing tool while wearing a face mask. This item consists of a sharp razor with a bag attached to catch.

When you begin the process of removing popcorn ceilings, make sure you. If you do not want to scrape the ceiling or wall, you can try sanding. Use a coarse-grit pole sander across the whole surface. The popcorn finish should loosen and fall off easily.

Be sure to sand evenly, starting in one corner and moving across the wall.