How to install recessed lighting in existing ceiling

Can you put recessed lights in a drop ceiling? How many recessed lights should I install? How to install Canless recessed lighting? When installing recessed lighting in an existing ceiling , a hole is cut in the ceiling that exactly fits the profile of a special remodeling can to keep from damaging the surrounding drywall.

Yes, buy IC recessed lights. Available at Depot, Lowes, and just about anywhere else - just double check that the ones you get are actually labeled right. When you install, you should caulk around the can (on attic side) to ensure a good. Some States allow the home owner to do the electrical, excluding main panels, meters service, hook ups etc. It will still have to be inspected.

Check with the wire inspector or building permits section of town hall to see what is allowed. Having access from above (with the attic being above your kitchen) is very helpful. If so, you can probably handle doing the job. Locate the ceiling joists on either side of the desired locations for each of the recessed lights using a stud finder. Most models of recessed lighting housing have four clips that clamp the can to the ceiling by pushing down on top of the.

Pull the clips in so they do not protrude outside the can. Slip the can’s box into the hole, and then push the can body up into the hole until its flange is tight to the. Trace the provided. From above the ceiling, find the existing electrical cable that comes from the wall switch and connect it to the new cable strung between the recessed lights.

Make the wire connections inside a new metal junction box. Be sure to attach the box cover after making the wire connections. Once you have settled on the location of your lights, remove the paper template from the recessed can packaging. DIY How To Install Ultra Thin Recessed LED Dimmable Ceiling Lights - Duration: 12:13.

Black Rabbit Homestead 2views. Installing New Construction Lights in an Existing Ceiling The trickiest part of installing recessed lighting in an existing ceiling is fitting the lights into the ceiling framing. The advantage to working with New Construction fixtures is that you have access to the space above the ceiling. As an Amazon Associate I earn from qualifying purchases. Repeat this for each light fixture.

If an attic is above the ceiling , run the wire from the attic. Remove the old light fixture and then remove the junction box in the ceiling above it. It is often necessary to use a saw to cut the junction from the joist to which it is attached.

Take care to avoid damaging wires, which can sometimes have a short span, making it more challenging to install a new housing. Inserting a recessed downlight As the light slides into the hole, the wire catches will catch on the ceiling and force out the springs so that they push down on the upper side of the ceiling boards holding the light unit in place. The excess wire gives you enough slack to wire the new fixtures. To power your new can lights, find an existing receptacle or switch box that contains a “hot” wire on a suitable circuit.

A good general rule for placement if to divide the height of the ceiling by two. The result is the amount of space to leave between each light. For example, recessed lighting spacing for an 8-foot high ceiling would be feet between each light.

This will give good spacing for general room lighting.