Osha scaffold planks

What are OSHA scaffolding inspection requirements? How much weight scaffolds should support? If you are going to buy scaffold planks and also have a need for scaffolding frames, or vice versa, we are undoubtedly the place to buy.

If you buy scaffolding planks from us, they ship from the same warehouse as your frames. Get free shipping on qualified OSHA Compliant Scaffolding Planks or Buy Online Pick Up in Store today in the Building Materials department. Electronic Planking Quiz. According to Federal labor statistics, more scaffold incidents are attributed to planking giving way than any other cause.

Additionally, almost of workers receive no safety training for erecting scaffolds and installing work platforms. ScaffoldMart carries a premium DI-Southern Yellow Pine Plank in lengths of 1 1 and ft. Hand selected and individually graded. Our plank is mill graded and is DI-certified and insured.

The ends are clipped with a 45-degree cut at all four corners to help prevent end shearing. The maximum permissible spans for 2xinch or wider planks shall be as shown in the following table. Response: OSHA does not require that scaffold planks be graded and stamped by a qualified grading agency. Scaffold planking must be able to support, without failure, its own weight and at least four times the intended load. Solid sawn woo fabricated planks , and fabricated platforms may be used as scaffold planks following the recommendations by the manufacturer or a lumber grading association or inspection agency.

Each platform unit (e.g., scaffold plank , fabricated plank , fabricated deck, or fabricated platform) shall be installed so that the space between adjacent units and the space between the platform and the uprights is no more than inch ( cm) wide, except where the employer can demonstrate that a wider space is necessary (for example, to fit around uprights when side brackets are used to extend the width of the platform). Nominally) Our SYP Scaffolding Boards are all top quality DI-Southern Yellow Pine Boards that are made especially for the Scaffolding Industry. They have rods running through the ends that help keep the boards from splitting along the length.

Also, the corners are clipped for safety. OSHA Grade Planks are made of Yellow Southern Pine, Clippe Rodded and OSHA Stamped. All planks are high by wide and rod and clipped. This threshold differs from Subpart M (fall protection) , which requires the use of fall protection at six feet for most construction activities. Scaffold boards (also called scaffold planks , walkboards, and OSHA boards) are an extremely important component to your scaffolding system as they carry your workers and the weight of your materials.

Your boards must meet strict OSHA standards before they can be used on your project. Not just any board will do. Employers must provide fall protection for every employee on scaffolding more than feet above a lower level.

This is not an area where you want to cut costs. A competent person should determine the fall protection for employees working on supported scaffolds. OSHA has provided a non-mandatory Appendix A to help contractors comply with the requirements of Subpart L. Construction scaffolding safety is paramount.

Each plank is permanently embossed along each edge with the following information: z-Plank – for identification. E RC – indication of premium grade scaffold plank. OSHA – indicating design is per OSHA requirements.

Date of Proof Loading. E Solid Sawn Scaffold Plank represents an evolutionary enhancement in the qualification of solid sawn scaffolding boards versus traditional DIplanks. E planks than visual grading alone found in traditional DIplanks. Laminated Scaffold Boards are available in varying bundle sizes of 4 5 and pieces and are normally shipped straight from the mill or one of our reload locations.

Aluminum Telescoping Work Plank with 2lb.